Blog

Calibrate Your Equipment to Maximize Results this Spring

Ewing Irrigation on February 9, 2021 in BlogNo Comments

Calibrate Your Equipment to Maximize Results this Spring graphic

Before the ground thaws and we launch into spring, take some time this winter to review the status of your equipment and tools. Specifically, backpack sprayers and spreaders can get out of alignment if they’re not calibrated.

Measuring and adjusting the amount of pesticide or fertilizer your equipment will apply over a target area is key to ensuring the overall health of plants and turf. Too much or too little can result in burned or damaged turf, which means calibration is a critical first step in making certain that your equipment is applying product uniformly and at the correct rate.

Proper calibration of the equipment you use day in and day out has many benefits, including:

  • Improving target pest (i.e. weeds, insect or disease) control
  • Preventing off-site damage
  • Creating a healthier turf
  • Reducing customer complaints
  • Saving money

To help set you up for success this spring, we’ve put together this handy checklist with steps for proper equipment calibration. Print it out to use as a guide or follow these steps as you review your equipment ahead of the busy spring season:

Steps for Calibrating a Backpack Sprayer

  1. Set up marking flags for the distance you need to cover.
  2. Fill your backpack sprayer tank half full with water.
  3. Time yourself spraying water between your marking flags.
  4. Spray water into a bucket for the same amount of time it took to cover the distance between marking flags. Repeat 2 more times and average the results.
  5. The average fluid ounces equals the number of gallons per acre.

Steps for Calibrating a Broadcast Spreader

  1. Determine how much fertilizer you will need to cover a 1,000 sq. ft. area. This can often be found on the fertilizer bag.
  2. Measure the effective swath width of your spreader—this is dependent on your walking speed.
    • Set the spreader to the middle setting and practice the spread on a solid surface.
    • Measure the distance of the effective swath. This is the area the fertilizer material hits before it begins to thin on.
  3. Determine the length of the run needed by dividing 1,000 by the width of the swath.
  4. Mark the beginning and end of the test run area. Measure out the weight of your fertilizer and make a note of it.
  5. Perform your practice run then weigh the remaining fertilizer in the hopper and subtract it from the original amount.
  6. Compare this to the manufacturers’ suggested output. If it’s different, adjust the spreader’s setting and retest until it matches the suggested output rate.

As we head into spring, get your equipment ready to work as hard as you do by calibrating it in order to maximize results. For more in-depth information on how to calibrate your equipment, here are two of our Ewing videos that may help:

Calibrate Your Equipment to Maximize Results this Spring graphic
Ewing Irrigation
We'd like to hear from you. Please provide feedback or ask questions in the comments below, and let us know how we can help.
No comments yet.

Leave a Reply